|
 WILTON 12 x 20 SEMI-AUTOMATIC
HORIZONTAL CUT-OFF BAND SAW MODEL #7060
Featuring:
-
Equipped with Wilton's exclusive swivel control panel which allows the
operator to access controls from the front or back of the machine
-
Standard with Wilton's exclusive 6 contact point blade guide assemblies
for greater accuracy and longer blade life. These adjustable guide
assemblies utilize cam follower bearings mounted on eccentric shafts on both
sides of the blade. Combined with the side bearings are carbide pads, which
are positioned close to the material being cut, guiding the blade on both
sides to guarantee accurate, square cuts. The back of the blade rides on two
load bearings mounted on a pivot shaft enabling both bearings to equally
share the load.
-
Patented Rapid Acting 3 jaw vise for simple, fast, and accurate set up.
For standard cut offs, the ridged design makes square cuts easy. This design
improves operator safety, allows for faster set up, increases through put,
thereby lowering costs per cut.
-
Standard variable speed drive allows the operator to fine tune the blade
speed to maximize the performance. This again results in higher efficiency
and lower costs per cut.
-
Blade wheel dia. - 17", cast iron
-
Cutting capacity at 90 degrees - 12" round, 12x35" rectangle
-
Cutting capacity at 45 degrees - 12" round, 12x12" rectangle
-
Heavy duty transmission utilizes hardened and ground gears operating in an
oil bath. This provides a smooth, quiet drive train and positive SFM to the
blade.
-
Saw head raised hydraulically after each cut
-
3 phase version
|
|
Specifications |
|
Model |
7060 |
|
Cutting
Capacity: |
|
|
At
90 degrees |
12" Round /
12" x 20" Rectangle |
|
At
45 degrees |
12" Round /
12" x 12" Rectangle |
|
Blade Size: |
1" x
.035" x 156" |
|
Blade Wheel
Diameter: |
17"
diameter, cast iron |
|
Blade Speeds: |
82 to 262 SFPM,
Variable speed |
|
Motor: |
3 HP, 3 phase,
230/460 volts |
|
Machine
Dimensions: |
87" L x
31.5" W x 53" H |
|
Height of Work
Table: |
25 1/4" |
|
Net Weight: |
1,144 lbs. |
|
Shipping Weight: |
1,279 lbs. |
|
Standard Features
-
Variable speed drive system allows the operator to fine-tune the blade speed
fast and easily
-
Exclusive swivel control panel
-
Heavy duty transmission utilizes hardened and ground gears operating in and
oil bath
-
Counterbalanced feed system is controlled by a dual system of counterbalance
springs working with a hydraulic cylinder
-
Saw head raised hydraulically after each cut
-
Cast iron band wheels
Standard Equipment
-
Exclusively PATENTED 3 jaw vise allows for faster set-up
-
Exclusive 6 contact point blade adjustable guide assemblies utilize cam
follower bearings mounted on eccentric shafts on both sides of the blade.
Combined with the side bearings are carbide pads, the back of the blade rides
on two load bearings mounted on a pivot shaft so both bearings share the load
equally
|
|
Click here for Bandsaw Blades!
|
