General Equipment FCS5AC RIP-R-STRIPPER

FCS5AC RIP-R-STRIPPER FLOOR STRIPPER

The FCS5AC RIP-R-STRIPPER is a highly productive solution for removing a wide range of floor covering materials found on both commercial and DIY projects. Its small size and light weight design makes it highly productive in hard to reach areas such as bathrooms, closet areas and stairways. The FCS5AC works circles around larger stripper machines that lack the same agility and maneuverability. Use it to also remove accumulated layers of thick wallpaper or other strippable materials from vertical surfaces. The ergonomically designed handle enhances balance and helps reduce vibration levels. Adjusts for use under toekick panels. The 5 inch (127 mm) scoring blade can be used to remove coverings from both wood and concrete surfaces.

• Two position operator handle.
• High capacity elastomeric mounts.
• Sealed ball bearings.
• Auto-Stop® carbon brushes.
• Integral current interruption protection.
• Paddle-type ON/OFF switch.

FCS5AC RIP-R-STRIPPER FLOOR STRIPPER

The FCS5AC RIP-R-STRIPPER is a highly productive solution for removing a wide range of floor covering materials found on both commercial and DIY projects. Its small size and light weight design makes it highly productive in hard to reach areas such as bathrooms, closet areas and stairways. The FCS5AC works circles around larger stripper machines that lack the same agility and maneuverability. Use it to also remove accumulated layers of thick wallpaper or other strippable materials from vertical surfaces. The ergonomically designed handle enhances balance and helps reduce vibration levels. Adjusts for use under toekick panels. The 5 inch (127 mm) scoring blade can be used to remove coverings from both wood and concrete surfaces.

Specifications:

POWER SOURCE
Type: Electric Motor: 1400 W, 115 VAC, 60HZ, 12 amperes
External Weight: 9 lbs (4.1 kg), less blade

General
Nominal Diameter: 3100/minute
Extension Cord: 16-2 SJ x 8 foot (2.4 m) length Dimensions: 15”L x 5”W x8”H (handle extended, w/blade)

Specifications:

POWER SOURCE
Type: Electric Motor: 1400 W, 115 VAC, 60HZ, 12 amperes
External Weight: 9 lbs (4.1 kg), less blade

General
Nominal Diameter: 3100/minute
Extension Cord: 16-2 SJ x 8 foot (2.4 m) length Dimensions: 15”L x 5”W x8”H (handle extended, w/blade)