Model T-22
This series consists of one model only, the T-22
horizontal press brake. Its special structure makes it ideal for press bending,
bending, punching, and cutting of all types of section bars, flat bars, and
tubes. The positioning of the cylinder under the workbench allows freedom of
action for any type of operation on the workbench, and the controls set at the
front of the machine give the operator a high degree of control over the working
area during the operating phases.
Our horizontal press brakes have the following
features: 1.) Most tonnage for dollar invested; 2.) Cylinder under work
table allowing for better accuracy and more work surface; 3) User performs
operation in front of the machine instead of the side of the machine making
it easier to produce quality products, and frontal position on our press
brakes is protected and practical position for the operator; 4.) The T-22
horizontal bending press uses two hand wheel for adjusting stroke in and
stroke out, making the T-22 one of the simplest horizontal press brakes to
operate, meaning more profit dollars to be produced.
The standard series is comprised of the T-22
horizontal press brake which stands for 22 metric tons of power (or 25
imperial tons). Twenty-five tons is the proper tonnage for approximately 50
% of all horizontal press brake applications out there. If your spending
the money on a horizontal press brake the operator should start with a
machine no lower than 25 tons if they want to capitalize on a greater amount
of profitable work that can be shifted to the machine. The T-22 employs our
unique cylinder under the table allowing for the perfect flat open work
table environment that will bring more profit to the end user. This series
is a simple series where the operator controls the stroke in and the stroke
back by two hand wheels. Simplicity means profit.
The workbench is manufactured in tempered and
ground steel, the carriage runs on double guides with dust scraper and forced
lubrication. The mobile pin moves at two speeds and the stroke is adjusted via a
high precision electrical limit switch. Lubrication system on the T-22
horizontal press brake allows for years of operation. To find out more about
the T-22 horizontal bend press, please call for a video and brochure.
|
Specifications |
|
Workbench Dimensions |
630x1100 |
|
Max operating pressure |
22 T |
|
Carriage Stroke |
200 mm |
|
Carriage Speed |
1750 mm |
|
Press bending capacity |
120x15 |
|
Tool Holding Pins |
|
|
Height |
120 |
|
Diameter |
55 |
| Hydraulic Power Unit |
45 |
| Power |
240V, 3Ph, 60Hz |
| Horizontal Bending Press
Dim -mm(w x l x h) |
630x1150x1050 |
| Weight (Kg) |
630 |
Call 1-800-458-3687 For Special Pricing
|
