|
CH140
EASY TO OPERATE • POWERFUL CHIP DISCHARGE • EASILY SERVICED
• INTERCHANGEABLE FEED CHUTES
Durable Design
The Valby CH 140 is the machine for people who have use for
a small durable chipper. You know this machine was built to
last because of the hefty 600 lb. weight. The heavy
cutter disk carries a lot of inertia, which helps
the chipper run smoother, is easier on the tractor, and
enables bigger pieces to be chipped without stalling the
tractor. The quality spherical roller bearings enable the
chipper to be used at any PTO speed, up to 1000 RPM. |
CH
140F with a direct feed
Ease of Operation
The low feeding point
ensures effortless feeding of the chipper.
The operator can stand with a straight back. The chipper
stands by itself on the ground and is easy to hook up or
remove from the tractor. |
Safety Features
The Valby chippers do not
have any knife motion toward the operator. This reduces risk
of material flying back through the feed chute. The
discharge height is under 4 feet so the chips fly out below
eye level. To accomplish safe operation in various wind
directions, the Valby chipper's discharge direction is
adjustable 360 degrees. An adjustable deflector bonnet
enables placing the chips near or far. The chipper feeds the
material smoothly and does not jerk it from
the operator's hands. The knives are counter sunk into the
disk for safety.
Ease of Service
The upper-housing of the
chipper folds up for easy access to the knives. The knives
can be sharpened about 50 times before replacement. The
changing of the knives takes about 10 minutes. The knives
are easy to get to, and no special tools are needed for the
change.
The
discharge chute is low so the chipper can be stored in low
buildings. |
