ICS 633GC Concrete Saw at

The ICS 633GC sets a new standard for what is possible in portable concrete cutting.

Designed for general contractors, construction repair and demolition, there is simply no better saw for the wide range of cutting requirements encountered on the job.

The 633GC cuts up to 16 inches and can make square corners without overcuts. It's great for irregular shaped holes or concrete pipe, minimizing the patchwork associated with breaking and chipping

Datasheet Catalog

Download Free

Features

6.2 cu-in (101cc) engine designed specifically for wet cutting concrete and an abrasive environment
Special crankshaft sealing and air filtration
Sprocket side-cover and guard flap designed for maximum operator safety
Easy access and simple maintenance requirements
Fixed-Position WallWalker^® helps ensure easier cuts in multiple positions
Diamond Chains with SealPro^® for maximum performance and chain life
Lightweight magnesium castings

Free Freight On Any Bar and Chain Order
When Ordered with a Saw!

Bar & Chain Selection

14"	73600 - 14" Guide Bar	Use One Guide Bar For Every Three Chains - After two Chains flip Guide bar over	633GC
14"	Block & Concrete with #4 or 1/2" Rebar	71486 TwinMAX-32	633GC
14"	For Harder Materials such as Granite, Concrete Filled Block with #6 or 5/8" Rebar	71705 TwinMAX-32 Plus	633GC
14"	For Abrasive Materials - Block & Hollow Brick	71610 TwinMAX-32 Abrasive	633GC
16"	71600-16" Guide Bar	Use One Guide Bar For Every Three Chains - After two Chains flip Guide bar over	633GC
16"	Block & Concrete with #4 or 1/2" Rebar	71607 TwinMax - 35	633GC
16"	For Harder Materials such as Granite, Concrete Filled Block with #6 or 5/8" Rebar	71706 TwinMAX-35 Plus	633GC
16"	For Abrasive Materials - Block & Hollow Brick	71611 TwinMAX-35 Abrasive	633GC

Specifications
Engine Type		2-Stroke Single Cylinder Air-Cooled
Displacement		6.2 cu.inch (101cc)
Horsepower		6.5 HP (4.8kw) @ 8700 RPM
Engine Speed		11,500 ± 500 RPM Mechanically governed 2500 - 2800 RPM idle
Chain Speed		4950 fpm (25 m/s), free running
Weight (with bar and chain)		27.5 lbs (12.5 kg)
Available Bar Lengths		Up to 16 inches (41cm)
Dimensions	Length	23 inches (58cm)
	Height	14 inches (35cm)
	Width	12 inches (30cm)
Carburetor		Walbro, Throttle shaft sealed
Starter		Dust and water shielded
Ignition		Special water resistant electronic ignition
Clutch		Three-weight, single spring Water and concrete shielded
Fuel Mix Ratio		25:1 gasoline-to-oil
Fuel Capacity		0.26 gal (1 liter) 12-15 minutes run time per tank Continuous full-load operation
Water Supply		Minimum 20 psi (1.5 bar)
Noise Level		102dB @ 1 meter
Vibration Level		8 meters/second (front handle)
Cutting Rates
Hard aggregates & steel		15-25 sq-in/min (90-160 sq-cm/min)
Medium aggregates		20-30 sq-in/min (160-190 sq-cm/min)
Masonry, Soft aggregates		30-50 sq-in/min (190-320 sq-cm/min)

ICS Frequently Asked Questions

For More Information And Technical Tips
Click Here