Plate Roll PR-609
Made in Taiwan
Sometimes you need just a little more than 4ft roll forming material. This is where the PR-609 shines. The PR-609 sheet metal roller has a maximum 6ft forming width, which can roll up to 9 gauge mild sheet steel. All functions of this machine are hydraulically controlled for increased durability, reliability and efficiency. The industrial grade hydraulic system is run off of a 3 hp 220 volt three phase motor. This is more than enough to handle the 9 gauge capacity all day long. The back roll on the PR-609 sheet metal roller is also controlled by the hydraulic system and has a digital position indicator, so the operator knows exactly where the roll is at all times.
The PR-609 is built to last like all Baileigh Industrial sheet metal rollers. It has a fully integrated plate steel frame. This setup keeps the forming rolls perfectly in alignment during the bending process. The PR-609s top roll has a very simple release mechanism to release work that has been wrapped around the top roll.
The PR-609 also has a foot pedestal to control some bending functions; forward, reverse, up, and down. For operator safety we have included dual emergency stop cables that are located on both the back and front of the machine. For more information on the PR-609, contact a representative today.
|Roll Speed||4.67 rpm.|
|Upper Roll Dia.||5.91 inch|
|Roll Adjustment Back||Hydraulic|
|Minimum Forming Dia||8.86 inch|
|Capacity (Mild Steel)||9 ga. (.150 inch)|
|Forming Width||72 inch|
|Power||220V / 3-phase|
|Shipping Weight||5,610 lbs.|
|Shipping Dimensions||114 x 32 x 52 inch|
ADD TO CART NOW TO SEE SOUTHERN TOOLS EXCLUSIVE BROTHER-IN-LAW DEAL & FREE SHIPPING ANYWHERE IN THE LOWER 48 STATES