MultiQuip JB8090 Rebar Bender

JB8090 Rebar Bender

This portable rebar bender was designed by a contractor and allows you to bend steel in place even in tight areas.

• Ideal for standard hook or off-set (dog leg) bends. Straightens rebar from less than 30 degrees

• Versatile design cannot be trapped against a wall or obstruction. Bending wheel is easily removed without tools

• Costs for couplers, joint welds and inspection delays are greatly minimized

• Saves time by allowing the removal of column forms prior to bending rebar

• Bends #8 1-inch (25 mm) rebar to an ACI approved radius and ideal for general purpose bending with up to #9 1 1/8-inch (29 mm) rebar

**All JB Series Rebar Benders require a seperately purchased drive motor to function.  See JPU1 below.

Applications

• 90° Standard Hook

• 180° Cane Hook

• Stirrup and Tie Hook

• Seismic Stirrup and Tie Hook

• Offset Bends

• Straightening

Click Here To Download The Manual

Accessories

• Two bending wheels

• 10-foot hose with coupler

JPU1 - Pump