Model T-22
This series consists of one model only, the T-22 horizontal press brake. Its special structure makes it ideal for press bending, bending, punching, and cutting of all
types of section bars, flat bars, and tubes. The positioning of the cylinder under the workbench allows freedom of action for any type of operation on the workbench, and the controls set at the
front of the machine give the operator a high degree of control over the working area during the operating phases.
Our horizontal press brakes have the following features: 1.) Most tonnage for dollar invested; 2.) Cylinder under work table allowing for better accuracy and more
work surface; 3) User performs operation in front of the machine instead of the side of the machine making it easier to produce quality products, and frontal position on our press brakes is
protected and practical position for the operator; 4.) The T-22 horizontal bending press uses two hand wheel for adjusting stroke in and stroke out, making the T-22 one of the simplest
horizontal press brakes to operate, meaning more profit dollars to be produced.
The standard series is comprised of the T-22 horizontal press brake which stands for 22 metric tons of power (or 25 imperial tons). Twenty-five tons is the proper
tonnage for approximately 50 % of all horizontal press brake applications out there. If your spending the money on a horizontal press brake the operator should start with a machine no lower
than 25 tons if they want to capitalize on a greater amount of profitable work that can be shifted to the machine. The T-22 employs our unique cylinder under the table allowing for the
perfect flat open work table environment that will bring more profit to the end user. This series is a simple series where the operator controls the stroke in and the stroke back by two hand
wheels. Simplicity means profit.
The workbench is manufactured in tempered and ground steel, the carriage runs on double guides with dust scraper and forced lubrication. The mobile pin moves at two
speeds and the stroke is adjusted via a high precision electrical limit switch. Lubrication system on the T-22 horizontal press brake allows for years of operation. To find out more
about the T-22 horizontal bend press, please call for a video and brochure.
There are no further details.
Specifications
|
Workbench Dimensions
|
630x1100
|
Max operating pressure
|
22 T
|
Carriage Stroke
|
200 mm
|
Carriage Speed
|
1750 mm
|
Press bending capacity
|
120x15
|
Tool Holding Pins
|
|
Height
|
120
|
Diameter
|
55
|
Hydraulic Power Unit
|
45
|
Power
|
240V, 3Ph, 60Hz
|
Horizontal Bending Press Dim -mm(w x l x h)
|
630x1150x1050
|
Weight (Kg)
|
630
|
Call 1-800-458-3687 For Special Pricing
There is no further information.
There are no listed accessories.