Model 960-251 4 x 60 Two Wheel Wet Belt Grinder

Ideal for lapidary, glass, and other finishing applications optimized by diamond abrasives

With diamond belts and the model 960-401 you will experience up to 100 times the life of expectancy of silicon carbide abrasives while attaining vastly superior results. Model 960-400 uses a 4 x 60 belt size. If you need a smaller width to best fit your application look at the model 960-251 which uses a 2.5 x 60 belt size.

Standard 60" belt 4" wide. Also available is 4000 FilterPAK, stainless steel tank with filter.

• 5000 or Variable-Speed surface feet per minute to optimize modern diamond abrasives
• 4 x 60 inch belt track
• Integrated water fed system including pump, water flow adjusting valve, dual 120 degree spray nozzles, stainless steel water receiver tray with drain, sump, and interconnecting flexible tubes
• 1HP NEMA 4x motor and switch for wet application
• Ground fault interrupter power distribution "rain" box with master switch for the grinder and feeder pump for maximum safety in wet grinding modes
• Cast aluminum frame for Burr King ruggedness
• Safe belt track guarding that is OSHA compliant
• Bearings are high quality and sealed for life
• Belt change is quick with a linear belt tension device
• Belt tracking is simple and effective
• Work position is adjustable from horizontal to vertical
• Platen is full belt and generously long
• Contact wheel, slack, or platen grinding
• Dry grinding is as simple as turning off the pump
• One year, limited warranty
• Made in the USA

Click on Part Number in Chart Below to be Directed Below for Pricing

Instruction Manual

Schematic

None Available at this Time