Dry Cutting:  12" Dry Abrasive Mitering Machines

12" Abrasive-Mitering Cutoff Catalog Page

Complete with 5 HP TEFC motor, magnetic starter with 110 volt at the pushbuttons, manually operated vise

Fast, Low Cost Cutting of Hardened Tool Steel, Drills, Reamers,
Bars, Pipe, Angle Iron, Tubing, Flat Stock & Rod.

Capacity: 1.75" solid • 3" pipe • 45 deg—2.25" Most Shapes Cutting Head can swivel 45 deg left of center. Indicators for 15 deg, 30 deg,
and 45 deg. Cutting head and pedestal are mounted on a rugged swing
arm secured in lubricated-for-life bearings. Lock to hold desired
angle is quick and easy to operate.

Use a steel blade (see options below) to cut plastic, and with an oiler to cut aluminum, copper and nonferrous material.

Abrasive Wheels:  Dry Reinforced Abrasive Cutting Wheels

Link for Everett Dry Cut Abrasive Blades

All the cutting wheel grades have been developed and extensively tested to produce quality
cuts on a wide range of material alloys, sizes and shapes.

As a manufacturer of abrasive wheels, we have other grades of wet and dry abrasive wheels to meet your specific requirements. Contact us for special diameter, thickness, arbor hole and drive pin requirements of abrasive wheels.

Fiberglass Internally Reinforced Resinoid Bond Aluminum Oxide Cutting Wheels
Woven fiberglass cloth is molded in the center of the abrasive wheel for break resistance.

Fiberglass Externally Reinforced Cutting Wheels
Woven fiberglass cloth is applied externally on both sides of the abrasive wheel for break resistance.