Dry Cutting:  20"-22" Dry Abrasive Mitering Machines

20"-22" Abrasive-Mitering Cutoff Catalog Page

Complete with 10 or 20 HP TEFC motor, magnetic starter with 110 volt at the pushbuttons, cabinet base, air-operated chain hold-down vise;
up to 60 deg right of center

Fast, Low Cost Cutting of Hardened Tool Steel, Drills, Reamers,
Bars, Pipe, Angle Iron, Tubing, Flat Stock & Rod.

Capacity: 90 deg 3" solid / 6" Most Shapes /
30 deg - 45 deg - 2.5 inches Most Solids - 4 inches Most Shapes

Cutting Head swivels 60 deg right of center. Indicators for 15 deg, 30 deg, and 45 deg. Cutting head and pedestal are mounted on a rugged swing arm secured in lubricated-for-life bearings. Lock to hold desired angle is quick and easy to operate.

Use a steel blade to cut plastic, and with an oil mist spray to cut aluminum, copper and nonferrous material

Cutting Speeds (average)

20"-22" Dry Abrasive Cutoff Machines

20"-22" Abrasive-Mitering Cutoff Catalog Page

20 HP Models

Complete with TEFC motor, magnetic starter with 110 volt at the pushbuttons, cabinet base,  V  shaped chain hold-down vise

20 HP Hydraulic Power Head Models (PH)

Complete with hydraulic power head, TEFC motor, magnetic starter with 110 volt at the pushbuttons, air operated “V" shaped chain hold-down vise

20 HP Hydraulic Power Head Models (PH) with patented Wheel Wear Compensator (WWC)

Complete with TEFC motor, magnetic starter with 110 volt at the pushbuttons, cabinet base and air operated “V” shaped chain hold-down vise

20 HP Models with patented Oscillation (OSC): For improved cutting, reduced burr and longer wheel life.

Complete with TEFC motor, magnetic starter with 110 volt at the pushbuttons, cabinet base and air operated V shaped chain hold-down vise

20 HP Hydraulic Power Head Models (PH) with patented Oscillation (OSC): For improved cutting, reduced burr and longer wheel life.

Complete with TEFC motor, magnetic starter with 110 volt at the pushbuttons, cabinet base and air operated “V” shaped chain hold-down vise

20 HP Hydraulic Power Head Models (PH) with patented Wheel Wear Compensator (WWC) Oscillation: For improved cutting, reduced burr and longer wheel life.

Complete with TEFC motor, magnetic starter with 110 volt at the pushbuttons, cabinet base and air operated “V” shaped chain hold-down vise

Note:
Double Action Air Vise holds both sides of cut. Opens to 4"
Double Action Cam Lock Vise holds both sides of cut. Opens to 3 1/2".
Work Length Gage automatically swings up out of the way when the part is cut.

Abrasive Wheels:  Dry Reinforced Abrasive Cutting Wheels

Link for Everett Dry Cut Abrasive Blades

All the cutting wheel grades have been developed and extensively tested to produce quality
cuts on a wide range of material alloys, sizes and shapes.

As a manufacturer of abrasive wheels, we have other grades of wet and dry abrasive wheels to meet your specific requirements. Contact us for special diameter, thickness, arbor hole and drive pin requirements of abrasive wheels.

Fiberglass Internally Reinforced Resinoid Bond Aluminum Oxide Cutting Wheels
Woven fiberglass cloth is molded in the center of the abrasive wheel for break resistance.

Fiberglass Externally Reinforced Cutting Wheels
Woven fiberglass cloth is applied externally on both sides of the abrasive wheel for break resistance.

Options/Accessories