Conquest 23 Spindle Line Borer

PNEUMATIC 23 SPINDLE IN LINE BORING MACHINE,

Pneumatically operated Foot Pedal for fast cycle times, 64-Inch Fence guided in a Precision Roller Track with two Flip Stops, Spring Loaded Index Pins, Down Stroke Operation for easy viewing, 430 pound crated + Blum or Mepla Hinge Head Available.

Features and Specifications

• 23 spindle boring head with heat treated, helical, OD ground STEEL gears
• Pneumatic operated head - with foot pedal, motor turns off when pedal released
• Two spring loaded index pins - one on each side of boring head
• Spindles only turn when boring head is moving - for added safety
• Adjustable boring speed
• Adjustable boring depth
• 64 inch fence with two flip stops included
• Spindle accepts 10mm shank bits/12 Left - 11 Right
• 32 mm. center to center spindles (1-1/4 inch)
• Spindle speed 3450 rpm
• Table height = 37 inch
• Maximum drilling depth from edge = 12 inch
• Center distance between first and last drill Spindle = 27.7 inch
• Baldor Motor or 2 hp - 208-230v Single phase
• 47 inch x 25-1/4' floor space
• Machine weight (approx.) = 420 lbs./470 lbs. Crated
• Optional Fence extensions and additional Fence Stops
• Built in the USA!

Why a Conquest Pneumatic 23?                        

• TEFC BALDOR Motor.
• Pneumatic Operation.
• 64 inch Fence Capacity.
• 2 Spring Loaded Index Pins.
• 2 Spring Loaded Hold Downs.
• 2 Heavy Duty Cast Flip Stops.
• Heat Treated Steel Helical Gears.
• 12 inch Throat Opening (capacity to drill from edge of board).
• Available Hinge Boring Attachment With 2-Minute Change Over!

Options

• Additional Fence Capacity and Flip Stops

Note: Units ending with an H can ONLY be used for hindge boring and ONLY when a Blum or Mepla head is purchased and added to the Line Boring Machine. 8MM bits are ONLY for the hindge type machine.

Atwood/Detel and Ritter are more expensive wth longer lead times.

Standard Specifications

• Stand.
• Adjustable Drilling Speed.
• Operating pressure of 80 - 100 psi.
• 64" fence capacity with two flip stops. (Optional 30" extensions.)
• 23-spindle line boring head with steel heat treated helical gears.
• 32mm centers, distance between first & last drill = 27.7".
• TEFC Baldor motor, 3,450 rpm, 2 hp - 230 volt (5.9 amps) 60 Hz Single Phase, turns off when pedal released.
• Accepts bits with 10mm shank, one flat side, 12 lefts & 11 rights.
• Machine weight = 420 lbs & 470 lbs crated.

Note: Units ending with an H can ONLY be used for hindge boring and ONLY when a Blum or Mepla head is purchased and added to the Line Boring Machine. 8MM bits are ONLY for the hindge type machine.