The Dake HV200 Tube Bender is designed to bend 1" to 2" material up to 90-degrees in one operation and is a must for any manufacturing/fabrication shop. The HV200
comes with choice of one of 26 standard heat-treated aluminum dies allowing for effective bending of a variety of material. The 2" die will bend up to .134 wall chrome moly, d.o.m. or electric
weld. Special die sets are also available. Separate power unit required. Dake offers two types of power units to operate the HV200, a Manual Hydraulic Pump (model #301121) and an Air/Pneumatic Pump
(model #302252) which requires 60-100 psi and 9 cfm.
Model HV200 shown.
Features:
BELT GRINDER AND FOOT VISE | ||
---|---|---|
Model | Part # | Description |
HV200 | 962003 | 90° Hydraulic bender - one (1) standard die |
Air Power Unit | 302252 | Air power unit for 90 degree bender |
Hand Pump | 301121 | Manual hand pump for 90 degree bender |
4" Inch Radius | 302357 | 3/4" Tubing |
4" Inch Radius | 302358 | 1" Tubing |
4" Inch Radius | 302359 | 1-1/8" Tubing |
4" Inch Radius | 302360 | 1-1/4" Tubing |
4" Inch Radius | 302361 | 1/2" Pipe |
4" Inch Radius | 302362 | 3/4" Pipe |
5" Inch Radius | 302264 | 3/4" Tubing |
5" Inch Radius | 302265 | 7/8" Tubing |
5" Inch Radius | 302266 | 1" Tubing |
5" Inch Radius | 302267 | 1-1/8" Tubing |
5" Inch Radius | 302268 | 1-1/4" Tubing |
5" Inch Radius | 302297 | 1/2" Pipe |
5" Inch Radius | 302269 | 3/4" Pipe |
6" Inch Radius | 302258 | 1-3/8" Tubing |
6" Inch Radius | 302260 | 1-1/2" Tubing |
6" Inch Radius | 302261 | 1-5/8" Tubing |
6" Inch Radius | 302262 | 1-3/4" Tubing |
6" Inch Radius | 302259 | 1" Pipe |
6" Inch Radius | 302263 | 1-1/4" Pipe |
6" Inch Radius | 302374 | 1-1/2" Pipe |
7" Inch Radius | 302253 | 1-1/2" Tubing |
7" Inch Radius | 302254 | 1-5/8" Tubing |
7" Inch Radius | 302256 | 1-3/4" Tubing |
7" Inch Radius | 302375 | 2" Tubing |
7" Inch Radius | 320055 | 1-1/4" Pipe |
7" Inch Radius | 302257 | 1-1/2" Pipe |
6" Inch Radius | 302356 | Flat Die Set |
5" Inch Radius | 302355 | 3/4"-1"-1-1/4" Square Set |